• GE Fanuc Automation Programmable Control Products Series 90®-30 Programmable Controller DeviceNet™ Modules GFK-2196 November 2002. • Features may be described herein which are not present in all hardware and software systems. GE Fanuc Automation assumes no obligation of notice to holders of this document with respect to changes subsequently made. • Operation of a Series 90-30 Slave (Server) DeviceNet Module.5-4 Fault Table Entries for a Series 90-30 DeviceNet Module.5-5 PLC Status References for a Series 90-30 DeviceNet Module.. 5-6 Device Status Bits for the Series 90-30 DeviceNet Master Module. 5-7 Chapter 6 Programmed Communications..6-1 COMMREQs for the Series 90-30 DeviceNet Modules..

GE Fanuc Automation Computer Numerical Control Products Series 15 / 150 – Model B Maintenance Manual GFZ-62075E/04 May 1998.

• Command Code 9: Reading Identification, Status, and Error Information. Ebook Jarimatika Perkalian. 6-8 Command Code 4: Getting the Status of a Network Device. 6-12 Command Code 5: Getting Status Information of a Series 90-30 DeviceNet Slave Module or the Server Function of a Master Module..6-14 Command Code 6: Getting Input Status from a Device.

• LED indications. Chapter 3: PLC Configuration for the DeviceNet Master, explains how to add a DeviceNet Master Module to the configuration of the Series 90-30 PLC. It also explains how to configure communications connections, the module, and the DeviceNet network. • Both of these modules can be installed in any rack in the Series 90-30 PLC.

Each module counts as a single node on the DeviceNet network. However, the server function of each module is easily configured for up to two DeviceNet I/O Messaging connections and for Explicit Messaging. • Series 90-30 DeviceNet Master Module The Series 90-30 DeviceNet Master Module (IC693DNM200) allows a Series 90-30 CPU to send and receive data over a DeviceNet network. It can act as master for up to 63 slaves on the DeviceNet network. It can also be configured to simultaneously function as a slave to another master on the bus. • Requires CIMPLICITY Machine Edition Logic Developer PLC version 3.0 with Service Pack for DeviceNet, or later.